Rotational Molding Process

What plastics can use the rotational molding process?

The main plastic used is the polyethylene family of plastics; PE, HDPE, LLDPE and HDPE. A few other plastics used in rotomolding include nylon, PVC, and polypropylene. rotomolding companies near me

Why is it called the rotational molding process?

It is called the rotational molding process because the mold rotates! It actually rotates in two axes. This is to enable the plastic to be evenly distributed over the molding surface of the mold. In the rotational molding process, a predetermined amount of plastic powder is placed in the mold and heated to it’s melting point. The mold is then rotated in two axes, which spreads the molten plastic over the face of the mold.

Are special molds required?

Most rotomolds are rather simple, especially compared to injection molds. When you consider that the finished product is a garbage bin, or kayak, it is understandable that the fit and finish need not be so exact.

The rotational molding design faces a different array of obstacles than a typical injection mold, and need to take these into consideration. A good example is the difficulty faced in the rotational molding process in attempting to fill highly detailed areas. Because the rotational molding process uses high temperature and low pressure, it can be rather limiting in its ability to fill corners and other hard to fill areas.

Is there a future in the rotational molding process?

Yes, there certainly is a future for rotomolding. The type of products typically produced by the rotational molding process are the type of thing that never goes out of style. Imagine the world without the green garbage cans or a playground without a plastic slide? Companies that embrace this low tech/high tech will certainly experience job offers.

Leave a Reply

Your email address will not be published. Required fields are marked *